GSO ISO 6002:2013
ISO 6002:1992
Gulf Standard
Historical
·
Approved on
01 April 2013
Bolted bonnet steel gate valves
GSO ISO 6002:2013 Files
English
12 Pages
Historical
Reference Language
29.87 BHD
GSO ISO 6002:2013 Scope
This International Standard specifies the requirements
for bolted bonnet steel gate valves having the
following features:
- bolted bonnet;
- outside screw and yoke;
- inside screw (alternative for PN IO, PN 16, PN 20,
PN 25 and PN 40 only);
- Single or double obturator;
- wedge or parallel seating;
- with or without non-metallic obturator or seat
Seals;
- flanged or butt-welding ends.
lt covers valves of the nominal sizes DN
10; 15; 20; 25; 32; 40; 50; 65; 80; 100; 125; 150; 200;
250; 300; 350; 400; 450; 500; 600; 700; 800; 900;
1 000,
and applies to valves of the nominal pressures PN
10; 16; 20; 25; 40; 50; 100.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993
Bahraini Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022
Gulf Standard
Gas cylinders
— Compatibility of cylinder and valve materials with gas contents
— Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021
Gulf Standard
Furniture
— Tests for surface finishes
— Part 5: Assessment of resistance to abrasion